System Manual

BreezeCOMPACT System Manual
65
Chapter 3: Operation and Administration
Procedures
BreezeCOMPACT Full C
onfiguration via CLI

set deployment topology SplitModef1f2

set cell
1 general
central-frequency <Frequency 1 in MHZ>

set cell
1 general
central-frequency-f2 < Frequency 2 in MHZ>
 Perform commit procedure as per 3.1
When running: show deployment topology
Result is: topology SplitModef1f2;
When running: show ran rh-ports-admin-state
Result is: port1-admin-state Operative; port2-admin-state Operative; port3-admin-state
Operative; port4-admin-state Operative;
When running: show cell ran-rf
result is:
bandwidth 5MHz;
tx-power 30;
When running: show cell0 general
result is:
central-frequency 3510.0;
central-frequency-f2 3540.0;
phy-cell-id 0;

show status ran port
result is :
PortsList 1 {
operational-status InService; admin-state InService;
}
PortsList 2 {
operational-status InService; admin-state InService;
}
PortsList 3 {
operational-status InService; admin-state InService;
}
PortsList 4 {
operational-status InService; admin-state InService;
}
On BREEZEVIEW when looking in Home->devices->ENB ->Device details: