System Manual

BreezeCOMPACT System Manual
When running from BreezeCompact> prompt :
 s
show status ran port
result is: PortsList 1 {
operational-status InService; admin-state InService;
}
PortsList 2 {
operational-status InService; admin-state InService;
}
PortsList 3 {
operational-status InService; admin-state RxOnly;
}
PortsList 4 {
operational-status InService; admin-state RxOnly;
}
On BreezeVIEW :
When clicking on the BreezeVIEW home->devices->ENB ->device details :
Figure 27: BREEZEVIEW -ENB Antenna's status in single carrier 4Rx/2Tx
When looking on Breeze view on the ENB deployment tab:
Figure 28: BREEZEVIEW -ENB deployment tab in single carrier 4Rx/2Tx
3.3.2.3.3
Single Carrier 4X4
In order to change the topology to Single carrier 4x4 , On BreezeCOMPACT CLI from
BreezeCompact% prompt perform the following commands :
 set deployment topology SingleCarrier4X4TM4
 Perform commit procedure as per 3.1
When running from % prompt: "show deployment topology" topology SingleCarrier4X4TM4;
When running from % prompt : " show ran rh-ports-admin-state" port1-admin-state Operative;
port2-admin-state Operative; port3-admin-state Operative; port4-admin-state Operative;