System Manual

BreezeCOMPACT System Manual
56
Chapter 3: Operation and Administration
Procedures
BreezeCOMPACT Full Configurati
on via CLI
3.3
BreezeCOMPACT Full Configuration via CLI
3.3.1
Purpose
This procedure describes how to configure the BreezeCOMPACT for full functionality.
3.3.2
Full Configuration via CLI Procedure
The following procedures must only be performed after the commissioning procedure described in
Chapter 3, Commissioning has been completed. The following procedures must be performed in
the same order as described below.
3.3.2.1
Configuring Device Settings
 Device general settings
At the B
BreezeCompact%
prompt, set parameters by entering the following
commands:
set device general device-id <The unique device ID>
set device general address <Address location of the device>
set device general area <Operator Area location of the device>
set device general contact <The name of the contact person>
set device general name <The name of the device and device site>
 Device management settings (DNS IP Address)
set device management primary-dns-ip-address <Primary DNS IP address>
set device management secondary-dns-ip-address <Secondary DNS IP address>
3.3.2.2
Configuring LTE TDD Configuration
In order to configure LTE TDD and special subframe configuration the following cli commands
should be performed from BreezeCompact% prompt:
 set cell ran-common cell-radius <cell radius number in km>
The value for the cell radius should be between 1-60 km

set deployment frame-structure subframe-Cfg <Sub frame configuration number >
The value for the sub frame configuration should be between 0-2 (These are the supported
values). Please see further explanation regarding the possible sub frames in 1.5.2.1

set deployment frame-structure special-subframe-Cfg <special sub frame
configuration number >
The value for the special sub frame configuration should be within 0-3 (These are the supported
values). Please see further explanation regarding the possible special sub frame configurations
in 1.5.2.2

set deployment wimax-coexisting <true or false>
It is recommended to set this value as true .This value is important to be set to true in order to
be avoided from mutual interference when WiMAX is running and additional LTE deployments.
In order to show the Implanted configuration, run the following command from BreezeCompact%
prompt:

show deployment
As a result, you will see the following output as an example: