Installation and Operation Instructions
Telrad Networks Ltd. BreezeAIR Installation Guide
Page 20 of 29
FCC Notice
This equipment has been tested and found to comply with the limits for Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
Reorient the relocate-receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device must accept any interference received including interference that may cause
undesired operation. Any unauthorized modification or changes to this device without the
express approval of Telrad Networks may void the user’s authority to operate this device.
Furthermore, this device intended to be used only when installed in accordance with the
instructions outlined in this manual. Failure to comply with these instructions may also void
the user’s authority to operate this device and/or the manufacturer’s warranty
2
2
.
.
4
4
C
C
o
o
n
n
s
s
e
e
c
c
u
u
t
t
i
i
v
v
e
e
A
A
P
P
c
c
o
o
n
n
n
n
e
e
c
c
t
t
i
i
o
o
n
n
Consecutive connection is done by plugging CAT5 cable between SU and consecutive MU.
This cable also provides power redundancy to the units.
Total length of all wires should not exceed 100 meters.
Figure 2-9: Consecutive link principle