User's Manual

Associating the EcoSwitch with an EcoInsight
EcoSwitch Installation Guide
Revision: 9
6
Associating the EcoSwitch with an EcoInsight
Connect the EcoSwitch to the ZigBee Network
1. Determine which EcoConnect will provide the ZigBee network for the EcoSwitch. The same EcoConnect
must be used for both the EcoInsight and the EcoSwitch.
2. Activate joining on the EcoConnect using the EcoCentral Virtual Engineer web interface or by pressing
the recessed button on the EcoConnect’s front plate. The green LED on the front of the EcoConnect
should blink green.
3. Press and hold the EcoSwitch for 10 seconds.
4. Verify the green LED on the EcoSwitch rapidly blinks green. If it does not blink or rapidly blinks red, see
“Issues Connecting the EcoSwitch to the ZigBee Network” in Troubleshooting on page 8.
Associate the EcoSwitch with the EcoInsight
5. Press the right-most button beneath the display on the EcoInsight six times.
6. Verify the EcoInsight shows “Learn” in the upper right-hand corner. See Figure 3.
Figure 3: Learn Mode on the EcoInsight
7. Press and hold the EcoSwitch for 5 seconds.
8. Verify the green LED on the EcoSwitch rapidly blinks green. If it does not blink or rapidly blinks red, see
“Issues Associating the EcoSwitch with the Thermostat” in Troubleshooting on page 8.