User's Manual

EcoSmart VRF Controller
I, O & M Guide
Telkonet, Inc.
For Use with Firmware Version 2.x
20800 Swenson Drive, Suite 175
Waukesha, WI 53186
Revision 2.3 [phone]
Page 4 www.telkonet.com
EcoAir/EcoTouch thermostats in different areas of a
building give each individual area the ability to make
setpoint changes to control a single EcoSource+.
Together, the EcoWave package forms a wireless
programmable controllable thermostat with over 125
configurable settings used to control the efficiency of
HVAC systems. It can be easily installed on packaged
terminal air conditioners, fan coils, heat pumps, split
systems, and more. With software-based relay control
and fan speed configuration, programming setup is
simple and fast.
Wiring follows industry-standard conventions whenever
possible. Telkonet can develop specific wiring diagrams,
if a complete specification is provided for the HVAC
unit(s) in use at the site. The pin allocations of the
EcoSource+ are below. The wiring interface conforms to
industry standards.
Functional Caveats
Telkonet ships equipment to customers pre-programmed
based on a pre-deployment analysis and discussion with
property management. Generally, command-level
programming at the field level will not be needed. When
a command change is needed, Telkonet will provide a
detailed synopsis of the proposed changes. Arbitrarily
changing command values without prior discussion with
Telkonet Applications Engineering can result in
suboptimal thermostat performance and a loss of energy
savings. All of these can possibly impact the user
interface. For this reason, such arbitrary changes do not
represent a Recommended Best Practice, and any
corrective actions taken by Telkonet (including
consultation) are subject to Professional Services charges
at prevailing rate.