User's Manual

ZigBee Wireless
EcoSmart VRF Controller
I, O & M Guide
Telkonet, Inc.
For Use with Firmware Version 2.x
20800 Swenson Drive, Suite 175
ZigBee Wireless Waukesha, WI 53186
Revision 2.3 [phone]
Page 13 www.telkonet.com
Table 1-Wiring
J4 Connector Wire 22AWG stranded
PIN # SIGNAL COLOR
1 F3 12VDC PLC (Power 3 communication on the same wires) BLUE *1 *2
2 F4 12VDC PLC WHITE *1 *2
3 RS485_N2 ORANGE Friedrich VRP
RS485_P2 YELLOW Friedrich VRP
5 GND GREEN *2
6 NC BLUE
7 RS485_N1 PURPLE
8 RS485_P1 GREY
9 GND (EcoAir) BLACK (Move J5 to inside pins)
10 3.3V (EcoAir) RED (Move J5 to inside pins)
11 SW1_IN BROWN (Dry contact)
12 SW2_IN RED (Dry contact)
13 SW3_IN ORANGE (Dry contact)
14 SW4_IN YELLOW (Dry contact)
15 SW5_IN GREEN (Dry contact)
16 SW6_IN BLUE Dry contact)
17 GND BLACK (Dry contact)
18 AOUT1 (Variable output) GREY (VO)
19 AOUT2 (Variable output) WHITE (VO)
20 AOUT3 (Variable output) BLACK (VO)
21 GND (Variable output) BROWN (VO)
22 NTC A1 RED (Temp probe)
23 GND (EcoTouch+) BLACK
24 12V (EcoTouch+) RED
25 VACCOM (24 VAC) GREEN (Move J5 to outside pins)
26 VAC (24VAC) BLUE (Remove J1 & J2)