User's Manual

Introduction
Conventions Used in this Guide
This is an informational tip, used to convey
relevant but not necessarily urgent
information.
This is a warning, used to convey important
information.
This is a strong warning, used to convey
urgent and often safety-related information.
Chapter Names
Main chapters in this manual will have headings in large green
font as shown above. Main chapter names also appear in the
footer.
Sub-Chap ter Names
Within the main chapters will be relevant sub-chapters, which
are presented with bold, black headings as shown above.
Footers
Footers contain the document name, chapter name, document
version number and page number, as shown here:
Procedure: Steps Described Here
Procedural Steps are indicated as such in the heading, which
begins with the word, “Procedure:” as shown above. The steps
are outlined as shown in the following example:
Step 1 Navigate to the Config Menu > Alert Setup.
Step 2 Clic k t he Add New Alert Trigger button in
the top left corner of the Alert Setup Screen.
Step 3 Enter a descriptive A lert Name.
Introducing a New Screen
When a screen is introduced, a screen print is provided. Below
the screen print will be its location and an explanation of the
screen’s intended purpose as shown in this example:
Screen and Tab Names
Screen and Tab names are underlined, as shown in this example:
The Thermostat Status Screen shows all rooms and
their status information at a glance.
Field Names
Field names appear in bold font; field explanations appear next
to the field name as shown in this example:
Device Select the device type.
Position The order in which attached devices are
associated.
MAC Address MAC address of the attached device.
Field Selection Choices
Field selection choices are in italics as shown in this example:
Select the Alerting Device Type from the dropdown
menu. Choices are: All Thermostats, All Pipe Sensors,
Single Device and Outdoor Temperature.
The “>” Sy mbol
The ">" symbol is used to describe a menu choice and command
selection. For example:
Configuration Menu > Alert Setup means click on the
Configuration Menu, then click on Alert Setup.
Tables
Tables provide visual presentations of related data such as
hardware components and explanations as shown in this
example:
Pin Label on Backplate Function
1
iaculis
Lorem ipsum dolor sit
amet.
2
velit
Fusce pharetra risus eu
nibh consequat volutpat.
3
sagittis
Uisque laoreet augue eu
elit dignissim feugiat.
Troubleshooting
Assistance with troubleshooting begins with the red header as
shown above.
EcoWave Featuring EcoTouch IO&M Guide Telkonet, Inc.
For Use with Firmware Version 2.x 20800 Swenson Drive, Suite 175
Introduction Waukesha, WI 53186
Revision 2 [phone]
Page 1 www.telkonet.com