User's Manual

EcoTouch Pairing
Device Association
Reminder: associating devices must be done in this order:
1. Set up EcoCommander.
2. Hard wire EcoConnect coordinators to the EcoCommander.
3. Create a network via the EcoConnect coordinator.
4. Join routers (e.g. EcoSources) to the EcoConnect coordinator.
5. Pair EcoTouch to EcoSource (see details below).
6. Pair EcoContact to EcoSource (if applicable).
7. Pair EcoSense to EcoSource (if applicable).
8. Bind routers and end devices (such as Control4, Saflok, etc.) in the room.
Pair EcoTouch with EcoSource
1. On the EcoTouch, “three-finger tap” anywhere on the screen. (“Three-finger tap” means to touch the
screen using 3 fingers, simultaneously; slightly spread out your fingers so all three fingers are
recognized by the screen.)
2. The System Status screen appears.
3. Press the Config button.
4. Enter the password C57A
5. Touch Enter.
6. Touch Pair.
7. On EcoSource, use a paperclip or pen to press the recessed button above the LED light one time (LED
will turn solid red).
8. Touch Search on EcoTouch.
9. EcoTouch will indicate “Searching for a thermostat to pair…”
10. “Success” message will appear: your EcoTouch is now paired to the EcoSource.
11. Back out of the screen by pressing Exit, then Exit, then Exit once again.
If fail, will show message, “ERROR! Failed to pair. No open EcoSource found.”
Typically the cause of the failure is that the EcoSource is not yet enabled for pairing.
Solution: Repeat the above steps, particularly Step 7.
See the Device Association Guide for detailed instructions on associating all devices.
EcoWave Featuring EcoTouch IO&M Guide Telkonet, Inc.
For Use with Firmware Version 2.x 20800 Swenson Drive, Suite 175
Waukesha, WI 53186
Revision 2 [phone]
Page 31 www.telkonet.com