User's Manual

EcoTouch Installation
-If your power is an AC 24V transformer, then connect the red wire and black wire to the top 2 pins; it does
not matter whether the red wire is on top and the black wire is in the 2
nd
slot from the top, or
vice versa.
-If your power is a 12-24VDC installation, then connect the black wire to the top pin (this is the “Ground” or
“Common” pin) and connect red wire to the 2
nd
pin-the pin just below the top pin (this is the “Power” pin).
Step 11 Place the cover over the backplate, about ¼ inch to the left as shown in Figure 29.
Figure 29: Replace Cover
Step 12 Slide the cover to the right to secure it.
Step 13 Screw in the security screw.
Your EcoTouch is now installed.
EcoWave Featuring EcoTouch IO&M Guide Telkonet, Inc.
For Use with Firmware Version 2.x 20800 Swenson Drive, Suite 175
EcoTouch Waukesha, WI 53186
Revision 2 [phone]
Page 28 www.telkonet.com