User's Manual

EcoSource High Voltage Installation
Figure 9: Backplate with UL-Rated Insulating Tape
Step 17 Line up the hinges on the thermostat to the notches on the backplate:
Figure 10-Line Up Hinges on Right
Step 18 Press the right side of the thermostat tightly against the back plate.
Step 19 Slowly bring the left side toward the wall. Use care not to force the faceplate closed. If you
encounter resistance, check to make sure no wires are pinched between components.
Caution: the metal pins (as shown in Figure 11) can be bent when replacing faceplates if too
much force is used.
EcoWave Featuring EcoTouch IO&M Guide Telkonet, Inc.
For Use with Firmware Version 2.x 20800 Swenson Drive, Suite 175
EcoSour ce Waukesha, WI 53186
Revision 2 [phone]
Page 12 www.telkonet.com