User's Manual

EcoSource High Voltage Installation
CAUTION!
• Weco terminal on-site wiring for high voltage installation is not allowed. You must use the pre-
shipped 16-guage wired backplate provided by Telkonet.
• High voltage installation should only be performed by a qualified heating & air conditioning
contractor or licensed electrician.
• Failure to understand and follow all instructions carefully before installing or operating this
device could cause personal injury and/or property damage.
• All wiring must conform to local and national electrical ordinances and codes.
• Prevent electrical shock, personal injury, and equipment damage: prior to installation or
service, disconnect system’s electric power at main fuse or circuit breaker box.
Figure 2: Telkonet JBOX Adapter Plate
For all high voltage installations a single gang mud ring must be mounted VERTICALLY on a JBOX. A Telkonet
JBOX Adapter Plate (see Figure 2) is required for all JBOX installations.
EcoSource High Voltage Required Equipment
• EcoSource (P/N: SS6500)
• EcoTouch (P/N: SS6560)
• High Voltage Backplate
• Telkonet High Voltage JBOX Adapter
• Two #6-32 1” screws
• Four #5 ½” coarse thread screws
• Voltmeter
• Level
• Phillips screwdriver
• UL rated insulating tape
• Wire stripper
• Wire cutter
• Wire nuts
EcoWave Featuring EcoTouch IO&M Guide Telkonet, Inc.
For Use with Firmware Version 2.x 20800 Swenson Drive, Suite 175
EcoSour ce Waukesha, WI 53186
Revision 2 [phone]
Page 7 www.telkonet.com