User's Manual

EcoContact+ IOM Guide Telkonet, Inc.
For Use With Firmware V. 2.x 20800 Swenson Drive, Suite 175
Installation Procedures Waukesha, WI 53186
Revision 4 [phone]
Page 12 www.telkonet.com
Step 7 Verify the magnet is facing the correct direction and is in line with the target on the
EcoContact+.
Step 8 Connect your thermostat to ESU. In ESU navigate to the Devices/Sensors tab. Verify that
the EcoContact+ listed under the EcoInsight or EcoSource. (This means it is bound to the
thermostat.)
Step 9 Also in the Devices/Sensors tab, verify that the EcoContact is communicating and sending
information packets: look for an increase of RX/TX packets on the EcoContact line.
Step 10 In the Devices/Sensors tab, Sensor Index, verify an entry for the EcoContact+, 2 entries if
you are configuring both Lanai and Occupancy.
FAQ: Will these notches interfere with the mounting surface?
A: No. When the adhesive strip is affixed, the notch will not
interfere whatsoever.