User's Manual

EcoContact+ IOM Guide Telkonet, Inc.
For Use With Firmware V. 2.x 20800 Swenson Drive, Suite 175
Installation Procedures Waukesha, WI 53186
Revision 4 [phone]
Page 11 www.telkonet.com
Step 12 Drop sensor with attached carriage into the door so that it is flush with the door edge.
Step 13 Drill a 7/8” hole in the frame and insert the magnet, target side out, into the door frame.
Reminder: components can be reversed if desired: magnet can be inserted in door/window and
sensor can be inserted in frame (excludes door/window and frames of metal construction; see
“Word of Caution” on page 9).
On‐DoorMountingOption
The rectangular or cylindrical magnets are used for the exterior mount:
If your magnet is the rectangular design, you may need to remove the detachable “feet” (see
Figure 4 below) for exceptionally tight spaces, such as recessed or narrow frames. The feet
should remain attached whenever space allows.
Step 1 Determine the appropriate location to install the sensor and magnet on the door and door
frame (see page 5).
Step 2 Make sure all mounting surfaces are clean and dry.
Step 3 The sensor features 2 targets. Determine which sensor target will be aligned with the
magnet target so that the targets are aligned when the door is closed. (Rectangle magnet
also has 2 targets. Determine which magnet target will be used.
Step 4 Rectangle magnet only: Remove one or both detachable feet as space dictates
Step 5 The magnet comes with an adhesive strip already attached. Remove the protective film
and adhere the magnet to the door frame.
Step 6 For the sensor, remove the plastic film from one side of the separate adhesive strip. Affix
the adhesive strip to the appropriate side of the sensor. Remove the protective film from
other side and affix the sensor to the door/window/frame.
Figure 4 Detachable "Feet" for Exceptionally Tight Spaces