User's Manual

EcoContact+ IOM Guide Telkonet, Inc.
For Use With Firmware V. 2.x 20800 Swenson Drive, Suite 175
Installation Procedures Waukesha, WI 53186
Revision 4 [phone]
Page 10 www.telkonet.com
Step 5 Touch the sensor’s target to the magnet’s target. Release when you hear 3 single beeps
(side target) or 3 double beeps (top target):
Join/Bind
Step 6 Join your EcoContact+ to the network and bind it with the thermostat. (See Device
Association Guide for instructions.)
Step 7 Continue with either In-Door Mounting Option (next) or On-Door Mounting Option (page
11).
In‐DoorMountingOption
Step 8 Connect sensor and carriage as shown here. You will hear a click:
Figure 3 Connect Carriage to Sensor
Step 9 Determine the best sensor and magnet locations, so that the targets are aligned when the
door is closed, and the maximum distance between interior mount magnet and sensor
when door/window is closed is 25mm.
Step 10 Mark the installation locations on the door and frame.
Step 11 Drill 7/8” hole for sensor/attached carriage.