User's Manual

EcoContact+ IOM Guide Telkonet, Inc.
For Use With Firmware V. 2.x 20800 Swenson Drive, Suite 175
Installation Procedures Waukesha, WI 53186
Revision 4 [phone]
Page 9 www.telkonet.com
WordofCautionaboutIn‐DoorMountinginMetalDoors/Frames
If your door/window or frame is constructed of metal, do NOT install the EcoContact sensor in it. Metal will
interfere with wireless signal.
The magnet, however, CAN be installed in a metal door/window or frame.
Component:
Install in
metal?
Install in non-metal (e.g. fiberglass, wood)?
Ec
oContact+ sensor NO Yes
Ec
oContact+ in-door magnet Yes Yes
InstallationProcedures
RequiredEquipment
On-Door Mount: In-Door Mount:
AAA Battery AAA Batter
y
1 Sensor 1 Senso
r
1 Magnet 1 Magnet Set
Adhesive strip Drill with Forstner drill bit
InstallAAABatteryinSensor
Step 1 Slide sensor cover away from the “target’ end of the sensor, and lift off the cover:
Figure 2 Remove Cover
Step 2 Install the AAA battery.
Step 3 Replace the cover.
IdentifyTargetSensortobeUsed
Step 4 Using the straight end of the extractor tool, press the EcoContact+ sensor button 8 times.
The LED will blink twice: