User's Manual

EcoSense+ IOM Guide Telkonet, Inc.
For Use With Firmware V. 2.x 20800 Swenson Drive, Suite 175
PIR Rotation Design Waukesha, WI 53186
Revision 2 [phone]
Page 7 www.telkonet.com
IfThere’sNoBed
 Mount on wall that people walk alongside.
 Aim at area that will detect the most foot
traffic.
DistancetoOccupant:
 If the occupants will likely be stationary
(e.g. sleeping in bed), position the
EcoSense within 12 feet of their expected
location.
 If the occupants will move occasionally
(e.g. working at desk), position the
EcoSense within12-18 feet of their
expected location.
 If the occupants will move regularly (e.g.
walking in hall), position the EcoSense
within 18-30 feet of their expected
location.
DistancetoEcoInsightorEcoSource
 There is no minimum distance between the
EcoSense+ and the EcoInsight or EcoSource.
LineofSight
 The EcoSense+ should not have its line of
sight to the EcoInsight or EcoSource
partially obstructed by grills, registers, or
spinning fan blades.
Obstructions
 Ensure the EcoSense+ is mounted with a
direct line-of-sight to the target area.
 The line-of-sight to the target should not
be obstructed by grills, registers, or
spinning fan blades.
OrientationandFacing
 The EcoSense+ can be mounted on a ceiling
or a wall.
PIR Rotation Design
Figure 1 PIR Rotation Design
Always use the set screw to rotate the PIR
sensor.
Do not force the PIR sensor or you risk
damaging the device.
Installation
Requiredequipment
 2 AA batteries (included in shipment)
 Pigtails (included in shipment)
 2 x 50lb EZ-Anchors with screws
 Screwdriver for wall screws
 1 Security screw screwdriver
 1 Angle set screw driver ( to adjust PIR
direction)
Step 1 Remove the EcoSense+ cover by gently
twisting the cover counterclockwise and
lifting it off.
Step 2 Install 2 AA batteries in the backplate.
Step 3 With the cover still off, rotate the
backplate so that the PIR will point toward
the appropriate occupancy detection zone.
(For more information, see “Where to Aim
PIR
page 6.)