User's Manual

High Voltage Installation (Non-Class 2)
EcoInsight+ SS6010 I, O & M Guide Telkonet, Inc.
For Use with Firmware Version 2.x 20800 Swenson Drive, Suite 175
High Voltage Installation (Non-Class 2) Waukesha, WI 53186
Revision 2.1 [phone]
Page 7 www.telkonet.com
High Voltage Installation (Non-Class 2)
(Note: for Low Voltage Installation instructions, see page 16.)
Required Equipment
 SS6010 (included)
 High Voltage Backplate (included)
 Molex harnesses as applicable (included)
 Telkonet High Voltage JBOX Adapter Plate
(included)
 JBOX

Two #6-32 1” screws
 Four #5 ½” coarse thread screws Voltmeter
 Level
 Phillips screwdriver
 UL rated insulating tape
 Wire stripper
 Wire nuts
Installation
For all high voltage installations a single gang mud ring must be mounted VERTICALLY on a
JBOX. A Telkonet JBOX Adapter Plate is required for all JBOX installations.