User's Manual

Advanced Command Menu
EcoInsight+ SS6010 I, O & M Guide Telkonet, Inc.
For Use with Firmware Version 2.x 20800 Swenson Drive, Suite 175
Advanced Command Menu Waukesha, WI 53186
Revision 2.1 [phone]
Page 43 www.telkonet.com
Advanced Command Menu
Table 7: Advanced Program Commands
Cmd
#
Function
01 Profile: Selects one of the three default configurations stored in the thermostat. Note that these default
configurations are separate from the profiles available through Advanced Command 13 or EcoCentral.
02 Sets the desired relay configuration from available defaults.
Relay Config
-AdvCmd 02
Option to change between embedded default Relay Configs.
Embedded options will vary per customer. Talk to your Telkonet support representative to find out what
relay options are available within your firmware. Alternatively EcoSmart Serial Utility can be used to
make a custom relay config or to load a relay config file that is sent from the Telkonet support team.
03 Sets the desired speed configuration from available defaults.
Speed Config
-Adv Cmd 03
Option to change between embedded default speed configs.
Embedded options will vary per customer. Talk to your Telkonet support representative to find out what
speed config options are available within your firmware. Alternatively EcoSmart Serial Utility can be
used to make a custom speed config or to load a speed config file that is sent from the Telkonet support
team.
04 Sets the changeover value for Heat Pump operation (c/o heat).
05 Sets the changeover value for Heat Pump operation (c/o cool)
06 Sets the minimum temperature for Deep Setback mode*.
07 Sets the maximum temperature for Deep Setback mode*.
08 Choosing (01) selects a heat only interface, selecting (00) removes the heat only interface. If cool only
is also selected, the system will default to auto only.
09 Choosing (01) selects a cool only interface, selecting (00) removes the cool only interface. If heat only is
also selected, the system will default to auto only.
10 Sets the auto mode overshoot required for opposing mode to be called.
11 Sets the Door Contact configuration to N/O (00) or N/C (01) (normally open or normally closed).
12 Displays the RH% in the bottom right corner of the screen if RH sensor is installed.
13 Permanent Profiles: