User's Manual

Low Voltage Installation (Class 2)
EcoInsight+ SS6010 I, O & M Guide Telkonet, Inc.
For Use with Firmware Version 2.x 20800 Swenson Drive, Suite 175
Low Voltage Installation (Class 2) Waukesha, WI 53186
Revision 2.1 [phone]
Page 17 www.telkonet.com
Additional Hardware:
Drywall Mount:

4 – 50 lb. EZ-Lock anchors and
provided screws
VERTICAL JBOX Mount:
 Telkonet JBOX Adapter Plate
 Two #6-32 1” screws
 Four #5 ½” coarse thread screws
HORIZONTAL JBOX Mount:
 Two #6-32 1” screws
Installation
1. If applicable, determine the location in the room where the thermostat will be installed. (See
SS6010 Location Planning section, page 5.)
2. Turn off power at SS6010 mounting location using a disconnect switch or breaker lockout/tag
out on appropriate breaker panel.
3. Test that power is off by using a voltmeter.
4. Remove the safety screw from the left side of the thermostat using the hex wrench. See
Figure 10.
Figure 10: Thermostat Side View