User's Manual

High Voltage Installation (Non-Class 2)
EcoInsight+ SS6010 I, O & M Guide Telkonet, Inc.
For Use with Firmware Version 2.x 20800 Swenson Drive, Suite 175
High Voltage Installation (Non-Class 2) Waukesha, WI 53186
Revision 2.1 [phone]
Page 12 www.telkonet.com
Figure 8: Backplate with UL-Rated Insulating Tape
2. Line up the hinges on the thermostat to the notches on the backplate. See Figure 9
Figure 9: Line Up Hinges on Right
3. Press the right side of the thermostat tightly against the back plate.
4. Slowly bring the left side toward the wall. Use care not to force the faceplate closed. If you encounter
resistance, check to make sure no wires are pinched between components.
5. Return the electrical circuit to operation. Remove all lockouts or tags from the circuit breaker and
enable any disconnects.
6. Verify the SS6010 thermostat display is active.
7. Test all components to make sure that you can engage both the heat and cool, and all supported fan
settings (high, low, etc.). Wiring is complete.
8. Once the thermostat has been snapped onto the back plate, use a hex wrench to insert the safety
screw.