User's Manual

High Voltage Installation (Non-Class 2)
EcoInsight+ SS6010 I, O & M Guide Telkonet, Inc.
For Use with Firmware Version 2.x 20800 Swenson Drive, Suite 175
High Voltage Installation (Non-Class 2) Waukesha, WI 53186
Revision 2.1 [phone]
Page 10 www.telkonet.com
12. Place thermostat backplate against the JBOX adapter plate. The adapter plate and backplate holes
should align if both are correctly oriented. See Figure 5.
13. Connect wires and harnesses as per the pinout tables in the Tables section, which begins on page 30.
14. Mount SS6010 backplate on top of JBOX adapter plate, using four #5 ½” coarse thread screws (or other
appropriate mounting screws).
Figure 5: Back Plate on Adapter Plate
15. Feed wire harnesses through the applicable holes in the backplate.
16. Connect the harnesses to the SS6010.
REMINDER: Wiring to J3 must exit the enclosure at Opening A of the backplate as shown in
Figure 6 and Figure 7 (page11). Wiring to all other connectors must exit the enclosure at
Opening B of the backplate.
Class 2 and Non-Class 2 wiring must not be mixed within a junction box or conduit run.