User's Manual

EcoView/EcoContact Telkonet, Inc.
Installation Guide 10200 W. Innovation Dr., Suite 300
Installation Milwaukee, WI 53226
Revision 1 [phone]
Page 2 www.telkonet.com
Installation of the EcoView/EcoContact
1. Review the table below and determine where the EcoView/EcoContact will be mounted.
Mounting
Consideration
Best Practice
Orientation
and Facing
The EcoView/EcoContact can be mounted either horizontally on a ceiling or
vertically on a wall. In both orientations, the EcoView/EcoContact should be
mounted facing the center of the room to provide the best occupancy detection.
Distance to
Occupant
If the occupants will likely be stationary…
(e.g. sleeping in bed)
Position the EcoView/EcoContact
within
12 feet of their expected location.
If the occupants will move occasionally…
(e.g. working at desk)
Position the EcoView/EcoContact
within
15 feet of their expected location.
If the occupants will move regularly…
(e.g. walking in hall)
Position the EcoView/EcoContact
within
20 feet of their expected location.
2. For EcoView, continue to next step. For EcoContact, continue to Step 12.
3. Remove the security screw from the EcoView.
4. Disconnect the face of the EcoView from the backplate by twisting the face counter-clockwise and
lifting the face out of the backplate.
5. Hold the backplate up to the wall and mark the placement for the wall anchors and mounting screws.
6. Mount the backplate to the wall using the wall anchors and mounting screws.
7. Insert two AA batteries into the EcoView.
8. Align the face of the EcoView with the backplate so that the security screw holes line up.
9. Reconnect the face of the EcoView to the backplate by placing it inside the backplate, then twisting
the face clockwise until it is secure.
10. Reinsert and tighten the security screw on the EcoView.
11. EcoView installation is complete.
12. Remove the security screw from the EcoContact.
13. Separate the backplate from the EcoContact.
14. Hold the backplate up to the wall and mark the placement for the wall anchors and mounting screws.
15. Mount the backplate to the wall using the wall anchors and mounting screws.
16. Insert two AA batteries into the EcoContact.
17. Hook the EcoContact to the hinges on the long edge of the backplate.
18. Gently swing the EcoContact closed onto the backplate until it snaps into place.
19. Reinsert and tighten the security screw on the EcoContact.
20. EcoContact installation is complete.