Owner's Manual

EcoInsight Thermostat Installation Guide
2
Warning: Before beginning, remove power from all relevant electrical outlets by turning off any appropriate circuit
breakers. Lockout and label all circuits in accordance with local code and always test with appropriate meter that
power is off.
Section 1: Tools Needed
• Security screw wrench provided by Telkonet
• Phillips head screwdriver
• Minimum of two wall anchors, two wall dogs (four anchors recommended)
Section 2: Thermostat Installation
Open the EcoInsight by removing the security screw from the left side of the product using the security screw
wrench. Then press the lever next to the security screw and open the faceplate.
When mounting the EcoInsight, be sure the placement allows wiring to come through the large rectangular hole on
the left side of the backplate.
Mark placement for wall anchors or wall dogs (minimum of two anchors required, four recommended). Attach the
backplate to the wall by inserting the wall anchors in the marked areas, and screwing the backplate into the wall
anchors. Do not overtighten the screws in order to avoid bowing the backplate