User's Manual
Table Of Contents
- SS5200 Thermostat
- In This Training Guide
- What is a “SmartSystem”?
- How Does it Work?
- What Happens While a Guest is in the Room?
- How Does the Sensor Know When the Room is Empty?
- If You Walk Into a Room That Feels Too Warm or Too Cool…
- Buttons on the Thermostat
- Pictures on the Thermostat
- Note to Housekeeping and Front Desk
- Slide Number 11
- When Housekeeping Finds a Problem in a Room
- Too Hot or Too Cold
- Temperature Won’t Go Lower/Higher
- Thermostat is Clicking
- Thermostat Won’t Respond
- What Happens While a Guest is in the Room?
- Installing a New Sensor
- Sensor Installation Steps - Overview
- Important Note About Installing a New Sensor
- Remove the Failed or Vandalized Sensor
- Insert Batteries
- Connect New Sensor to the Base
- After the Sensor is Installed
- Installing a New Thermostat
- Thermostat Installation Steps - Overview
- Important Note About Installing a New Thermostat
- Unlock the Thermostat
- Remove Failed or Vandalized Thermostat
- Attach New Thermostat to Base Plate
- After the Thermostat is Installed
- Link the Sensor to the Thermostat
- Unlock the Thermostat
- The Hidden Buttons
- Pressing the Buttons
- Unlock the Buttons (NOTE: New Thermostat Will Already Have Unlocked Buttons)
- Erase Old Sensors From Thermostat’s Memory
- Put the Thermostat into “Learn” Mode
- Establish Radio Link
- Check the Signal Strength
- Double Check Radio Link
- Lock the Buttons
- Lock the Thermostat Cover
- Troubleshooting
- Equipment Maintenance
- What Does the Flashing Wrench Mean?
- Low Batteries?
- Flashing Wrench Problem Solved
- If the Screen Went Completely Blank, Displays an “Inkblot” on the Front or Thermostat Has Been Crushed or Stolen
- If a Button is “Stuck”
- What if All of the Symbols are Starting to Appear on the Screen?
- What if the Thermostat is Clicking Loudly?
- Need Help?
- Product Return Procedures
- Thank you for your cooperation.
Connect New Sensor
to the Base
•
Re-attach the main body of the Sensor to
the ceiling mounted base by aligning the
slots with the tabs. Hold base plate in
place and turn clockwise until it snaps
into place. If it doesn’t line up, spin the
sensor ¼
turn and try again. Be sure the
security screw is aligned on both sides.