User's Manual Part 3

Table Of Contents

6.70.104 SS2000 / SS2200 Association Procedures 5/2010

Figure 3 : Thermostat showing Signal Strength from Sensor

7. Observe the signal strength. The desired value is anywhere from 5 to 9. If a lower

value is shown, re-position the sensor and test. Do not deploy a Sensor to a location

yielding a signal strength less than 5.

8. If associating multiple Sensors, press the % button while the Thermostat is still in

Learn Mode. The Thermostat will display a number from 0-9. Repeat steps 5 – 7

above.

Step Three – Confirm the Association

9. While the Thermostat is still in Learn mode, press the % button twice. The

Thermostat will display 2 (the command code for Sensor association).

10. Use the Up Arrow to increase the 2 to 4, and press the % button. “4” is the command

code to ask the Thermostat to display the number of Sensors associated to it.

11. The Thermostat will display the number of associated sensors.

Note: After poking a sensor, you may note the display changes, seemingly at random. This is the

Thermostat acknowledging six consecutive data packets from the Sensor, and is normal.

Confidential – Information contained in this document is considered proprietary and confidential, and is intended for the internal

use of Telkonet, Inc. our contracted Partners and VARs, and customers. This content is protected by all applicable copyright