User's Manual Part 3

Table Of Contents

6.70.104 SS2000 / SS2200 Association Procedures 5/2010

Procedures: SS2000 / SS2200 to SS5000 / SS5200

Thermostat

Unlocking the Command Mode

NOTE: In some cases, depending on the installation and previous deployment, the SS5000 /

SS5200 may have its command buttons “locked” to prevent tampering. If the procedures in “Step

One” below do not allow control of the thermostat, follow these steps to unlock the Command

functions

1. Press and hold the Fan button for ~7-10 seconds.

2. The display will change to show all icons:

3. Press the Fan button. This will toggle the command lock on and off (“on” shown

below)

Specific sites may have custom procedures, which are no addressed in this Technical Note. Contact

Telkonet Applications Engineering if these steps are not appropriate for your site.

Confidential – Information contained in this document is considered proprietary and confidential, and is intended for the internal

use of Telkonet, Inc. our contracted Partners and VARs, and customers. This content is protected by all applicable copyright