User Guide

WE866C6 Hardware Design Guide
1VV0301658 Rev. 1 Page 51 of 58 2020-06-16
11. CONFORMITY ASSESSMENT ISSUES
Declaration of Conformity
Hereby, Telit Communications S.p.A declares that the WIFI/BT Wireless Module is in
compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet address:
http://www.telit.com\red
FCC/IC Compliance
Hereby, Telit Communications S.p.A declares that the WE866C6 Module is in compliance
with:
- USA: Applicable parts of the Title 47 of the Code of Federal Regulations (CFR);
- Canada: Radio Standard Procedure RSP-100, applicable Radio Standards
Specifications (RSS).
Note: In Canada, the device won’t operate in the frequency range 5600 – 5650
MHz (channels within this range won’t be used)”
Modification statement
Telit has not approved any changes or modifications to this device by the user. Any changes
or modifications could void the user’s authority to operate the equipment.
Telit n’approuve aucune modification apportée à l’appareil par l’utilisateur, quelle qu’en soit
la nature. Tout changement ou modification peuvent annuler le droit d’utilisation de
l’appareil par l’utilisateur.
Interference statement
This device complies with Part 15 of the FCC Rules and Industry Canada licence-exempt
RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
Wireless notice
This device complies with FCC/ISED radiation exposure limits set forth for an uncontrolled
environment and meets the FCC radio frequency (RF) Exposure Guidelines and RSS‐102
of the ISED radio frequency (RF) Exposure rules. This transmitter must not be co-located