User's Manual
Table Of Contents
- 1 Introduction
- 2 Block Diagram
- 3 Application Interface
- 3.1 Power Supply
- 3.2 Power-up / -down Slew-Rate
- 3.3 Reset
- 3.4 Supply Voltage Monitor
- 3.5 Serial Interface
- 3.6 GPIO Interface
- 3.7 I2C Interface0F
- 3.8 SPI Serial Peripheral Interface1F
- 1.1
- 3.9 Bluetooth Radio Interface
- 3.10 WLAN Coexistence Interface2F
- 3.11 Slow Clock Interface
- 3.12 Test Mode Enable
- 3.13 Pin Strapped System Memory Boot Mode Invocation
- 3.14 Operating in a Power-Switched Environment
- 3.15 Serial Wire Interface
- 4 Module Pins
- 5 Electrical Characteristics
- 6 Mechanical Characteristics
- 1
- 7 Application Diagram
- 8 Approvals/Certifications
- 9 Related Documents
- 10 Packing
- 11 Ordering Information
BlueMod+SR/AI
BlueMod+SR/AP
Hardware Reference
Release r04d01 www.stollmann.de Page 59 of 65
8.5 RoHS Declaration
Declaration of environmental compatibility for supplied products:
Hereby we declare to our best present knowledge based on declaration of our suppliers that this
product do not contain by now the following substances which are banned by Directive 2011/65/EU
(RoHS 2) or if contain a maximum concentration of 0,1% by weight in homogeneous materials for
• Mercury and mercury compounds
• Chromium (VI)
• PBB (polybrominated biphenyl) category
• PBDE (polybrominated biphenyl ether) category
• And a maximum concentration of 0,01% by weight in homogeneous materials for
• Cadmium and cadmium compounds
9 Related Documents
[1] CD00171190.pdf Oct. 2011 Rev 14 (STM32_Reference)
[2] CD00191185.pdf April 2011 Rev 8 (STM32_datasheet)
[3] Stollmann: UICP_UART_Interface_Control_Protocol_r01.pdf
[4] Stollmann: AppNote_B0601_Antenna_Design_V1_0.pdf
[5] Stollmann: BlueMod+SR AT Command Reference
[6] Stollmann: BlueMod+SR_Startup_Timing_r01.pdf