User's Manual
Table Of Contents
- 1 Introduction
- 2 Block Diagram
- 3 Application Interface- 3.1 Power Supply
- 3.2 Power-up / -down Slew-Rate
- 3.3 Reset
- 3.4 Supply Voltage Monitor
- 3.5 Serial Interface
- 3.6 GPIO Interface
- 3.7 I2C Interface0F
- 3.8 SPI Serial Peripheral Interface1F
- 1.1
- 3.9 Bluetooth Radio Interface
- 3.10 WLAN Coexistence Interface2F
- 3.11 Slow Clock Interface
- 3.12 Test Mode Enable
- 3.13 Pin Strapped System Memory Boot Mode Invocation
- 3.14 Operating in a Power-Switched Environment
- 3.15 Serial Wire Interface
 
- 4 Module Pins
- 5 Electrical Characteristics
- 6 Mechanical Characteristics
- 1
- 7 Application Diagram
- 8 Approvals/Certifications
- 9 Related Documents
- 10 Packing
- 11 Ordering Information
BlueMod+SR/AI 
BlueMod+SR/AP 
Hardware Reference 
Release r04d01  www.stollmann.de    Page 36 of 65 
5.7.2  GFSK, PI/4 DQPSK, 8DPSK Transmitter 
VSUP = 2,5V to 3,6V, T
amb
 = +20°C
Measured conducted according to BT specification v1.2/2.0/2.0 + EDR/2.1/2.1 + EDR/3.0/3.0 + HS/4.0 
Trans
mitt
er 
Frequency [GHz]  Limit  BT 
Unit 
RF transmit power 
50 Ω load, at antenna 
Class 1 device GFSK 
b)
2.402  2,7  5,5   
0 to 20  dBm 
2.441  4,7  7,5   
2.480  5,7  8,5   
RF transmit power 
50 Ω load, at antenna 
Class 1 device EDR2, π/4 
DQPSK 
b)
2.402 GFSK    2,0   
∆TX = 
-4 to 1 
dBm 
2.402 π/4 DQPSK    0,9   
2.441 GFSK    4,7   
2.441 π/4 DQPSK    3,7   
2.480 GFSK    5,6   
2.480 π/4 DQPSK    4,6   
RF transmit power 
50 Ω load, at antenna 
Class 1 device EDR3, 8DPSK 
b)
2.402 GFSK    2,1   
∆TX = 
-4 to 1 
dBm 
2.402 8DPSK    1,0   
2.441 8GFSK
    4,8   
2.441 8DPSK    3,7   
2.480 GFSK    5,6   
2.480 8DPSK    4,6   
RF power control range   16  30    ≥16  dB 
RF power range control resolution  2  4  8  2 to 8  dB 
20 dB bandwidth for modulated carrier    925  1000 
≤1000 
kHz 
ICFT  -75  ±25  +75 
≤ ±75 
kHz 
Carrier frequency drift (packet DH1)    7   25 
≤ 25 
kHz 
Drift Rate    5  20  ≤ 20 
kHz/ 
50µs 
∆f1
avg
 “Maximum Modulation” 
140  164  175 
≥140 to 
≤175 
kHz 
∆f2
max
 “Minimum Modulation” 
115  140    >115  kHz 
∆f2
avg
 /∆f1
avg
0,8  0,91   
≥ 0,8 










