User's Manual
Table Of Contents
- 1 Introduction
- 2 Block Diagram
- 3 Application Interface
- 3.1 Power Supply
- 3.2 Power-up / -down Slew-Rate
- 3.3 Reset
- 3.4 Supply Voltage Monitor
- 3.5 Serial Interface
- 3.6 GPIO Interface
- 3.7 I2C Interface0F
- 3.8 SPI Serial Peripheral Interface1F
- 1.1
- 3.9 Bluetooth Radio Interface
- 3.10 WLAN Coexistence Interface2F
- 3.11 Slow Clock Interface
- 3.12 Test Mode Enable
- 3.13 Pin Strapped System Memory Boot Mode Invocation
- 3.14 Operating in a Power-Switched Environment
- 3.15 Serial Wire Interface
- 4 Module Pins
- 5 Electrical Characteristics
- 6 Mechanical Characteristics
- 1
- 7 Application Diagram
- 8 Approvals/Certifications
- 9 Related Documents
- 10 Packing
- 11 Ordering Information
BlueMod+SR/AI
BlueMod+SR/AP
Hardware Reference
Release r04d01 www.stollmann.de Page 34 of 65
Receiver
Frequency [GHz] Limit BT
Unit
Min Typ
Max
Spec
Adj. channel selectivity C/I f = f0 + 1MHz 8DPSK -4 5
≤ 5
dB
Adj. channel selectivity C/I f = f0 - 1MHz 8DPSK -1 5
≤ 5
dB
Adj. channel selectivity C/I f ≥ f0 + 2MHz 8DPSK
-36 -25
≤ -25
dB
Adj. channel selectivity C/I f ≤ f0 - 2MHz 8DPSK
-31 -13
≤ -13
dB
Adj. channel selectivity C/I f ≥ f0 + 3MHz 8DPSK
-42 -33
≤ -33
dB
Adj. channel selectivity C/I f ≤ f0 - 5MHz 8DPSK
-43 -33
≤ -33
dB
Adj. channel selectivity C/I f = fimage 8DPSK -14 0
≤ -0
dB