User's Manual
Table Of Contents
- 1 Introduction
- 2 General Product Description
- 3 Application Interface
- 3.1 Power Supply
- 3.2 Reset
- 3.3 Serial Interface
- 3.4 GPIO Interface
- 3.5 I2C Interface 0F
- 3.6 SPI Serial Peripheral Interface
- 3.7 Bluetooth Radio Interface
- 1.1
- 3.8 NFC Function
- 3.9 Slow Clock Interface
- 3.10 Test Mode
- 3.11 Operating in a Power-Switched Environment
- 3.12 Serial Wire Debug Interface
- 3.13 DC/DC Converter
- 4 Module Pins
- 5 Electrical Characteristics
- 6 Mechanical Characteristics
- 7 Application Diagram
- 8 Compliances
- 9 Packing
- 10 Ordering Information
- 11 Safety Recommendations
- 12 Document History
BlueMod+S42 Hardware User Guide
1VV0301303 Rev.3 – 2016-08-22
Reproduction forbidden without written authorization from Telit Communications S.p.A. - All Rights Reserved.
Page 57 of 62
8.4 KCC Certification
The BlueMod+S42/AI will be certified in Korea under the Clause 2, Article 58-2 of Radio
Waves Act.
KCC Certification is in progress
8.4.1 KCC Certificate
8.5 Bluetooth Qualification
The BlueMod+S42 will be a qualified design according to the Bluetooth Qualification
Program Reference Document (PRD) V2.3.
The BTSIG qualification is in progress
The Declaration ID is:
The Qualified Design ID is:
tbd
For further information about marking requirements of your product attention should be paid
the Bluetooth Brand Usage Guide at
https://www.bluetooth.org/en-us/bluetooth-brand/bluetooth-brand
According to the Bluetooth SIG rules (Bluetooth Declaration Process Document – DPD) you
must complete a Product Listing and Declaration of Compliance (DoC) referencing the
Qualified Design (QDID) for your product. For further information see www.Bluetooth.org
or
contact Telit.
8.6 RoHS Declaration
RoHS evaluation is in progress