User's Manual

BlueMod+S/AI
www.stollmann.de Page 45 of 52
8.3.4 IC RF-exposure Statement
This equipment is portable device. The output power of this device is less than 20mW.
The SAR test is not required.
8.3.5 IC Labeling Requirements for the End Product
Any end product integrating the BlueMod+S/AI must be labeled with at least the following
information:
This device contains transmitter with
FCC ID: RFRMS
IC-ID: 4957A-MS
8.3.6 IC Label Information BlueMod+S
The BlueMod+S shows no IC-ID on the product label, because there is no space available. IC
allows on request to state the IC-ID in the product manual. This product has been granted to do so.
Model: BlueMod+S
The IC-ID is: 4957A-MS
8.4 Bluetooth Qualification
The BlueMod+S is a qualified design according to the Bluetooth Qualification Program Reference
Document (PRD) V2.1. The Qualified Design ID (QDID) is:
tbd
For further information about marking requirements of your product attention should be paid the
Bluetooth Product Marking Guide at
https://www.bluetooth.org/Download/Marking_Guide_20060601.pdf
According to the Bluetooth SIG rules (Qualification Program Reference Document – PRD V2.1)
you are required to perform the mandatory End Product Listing (EPL) for your product. For further
information see www.Bluetooth.org or contact Stollmann.