User's Manual
Table Of Contents
- 1 Introduction
- 2 Block Diagram
- 3 Application Interface
- 4 Module Pins
- 5 Electrical Characteristics
- 6 Mechanical Characteristics
- 7 Application Diagram
- 8 Approvals/Certifications
- 9 Related Documents
- 10 Packing
- 11 Ordering Information
- 12 History
BlueMod+S/AI
www.stollmann.de Page 34 of 52
5.7.3 Antenna-Gain and Radiation Pattern
If BlueMod+S/AI is integrated into an end product while the recommendations depicted in 6.4
Placement Recommendation are maintained, the following typical antenna radiation patterns can
be expected.
Radiation Pattern will depend on the end products PCB size, masses in the antenna environment,
housing material and geometrics.
tbd.
Figure 11: Typical Antenna Radiation Pattern at 2402MHz
tbd.
Figure 12: Typical Antenna Radiation Pattern at 2441MHz
tbd.
Figure 13: Typical Antenna Radiation Pattern at 2480MHz
5.8 Power-Up Time
The time until the BlueMod+S is able to accept link requests or serial data depends on the
firmware version. In the TIO firmware version tbd. the module is command ready after at least tbd.
s. Bluetooth links are accepted tbd. s after reset.
Note: For further information refer to the document BlueMod+S_Startup_Timing