User's Manual
Table Of Contents
- 1 Introduction
- 2 Block Diagram
- 3 Application Interface
- 4 Module Pins
- 5 Electrical Characteristics
- 6 Mechanical Characteristics
- 7 Application Diagram
- 8 Approvals/Certifications
- 9 Related Documents
- 10 Packing
- 11 Ordering Information
- 12 History
BlueMod+S/AI
Hardware Reference
www.stollmann.de Page 11 of 52
3 Application Interface
3.1 Power Supply
BlueMod+S require a power supply with the following characteristics:
Typical: 3,0V
DC
, min.: 1,8V
DC
, max.: 3,6V
DC
, thereby delivering > 25 mA peak
BlueMod+S is designed to be powered from 3V coin cell batteries e.g. CR2032 directly, or any
other power source complying with the given requirements. For optimal performance a stable
supply is recommended.
BlueMod+S
XC6204B-3.3
E-6,F-6
VSUP
GND:
A-7,E-7,F-7,B-[5:8],
C-[5:8],D-8,E-8,F-8
10µ + 100n
1µ
VOUT
VSS
VIN
CE
5 1
3
2
+5VDC
Figure 2: BlueMod+S Example Power Supply with LDO
3.2 Power-up Slew-Rate
Parameter Min Max Unit
VSUP rise time rate
(1), (2)
0 60 ms
(1)
0V to 1,8V
(2)
The on-chip power-on reset circuitry may not function properly for rise times outside the
specified interval
Table 1: Power up Rise Time Requirements