User's Manual
Table Of Contents
- Introduction
- Block Diagram
- Application Interface
- Pin Description
- Electrical Characteristics
- Mechanical Characteristics
- Approvals/Certifications
- Related Documents
- Ordering Information
- History
BlueMod+C11/G2
Hardware Reference
www.stollmann.de Page 5 of 42
1 Introduction
This Hardware Reference Guide documents how BlueMod+C11/G2 can be inte-
grated into customer systems.
It addresses developers of hardware environments for BlueMod+C11/G2.
For detailed information about software interfaces refer to the software reference
manual.
The BlueMod+C11/G2 is available with EDR functionality disabled and enabled. For
the product with EDR disabled all information given in the following chapters regard-
ing EDR performance and functionality is not valid. Information regarding EDR per-
formance and functionality applies only to the BlueMod+C11/G2 with EDR functio-
nality enabled.
For the latest version of this document please check the following URL:
http://www.stollmann.de/en/modules/bluetooth-products/bluemod-c11g2/
1.1 Feature Summary
Bluetooth specification V2.0+EDR
EDR compliant with V2.0 of specification for 2Mbps and 3Mbps modulation
modes
Full Speed Bluetooth Operation with Full Piconet Support
Scatternet Support
Complete Co-location and Co-existence with 802.11 (AWMA, AFH and SFH)
Fast Connection Setup
RF output power class 1 with power control
Supply Voltage 3.0V to 3.6V
Internal crystal oscillator (26 MHz BC04 and 14,7456MHz for ARM7)
Full Bluetooth data rate up to 2178 kbps asymmetric
Support for very low-power modes (sleep and deep sleep)
Full 8- to 128-bit encryption
High sensitivity design ( -87 dBm typ.)
Extra ARM7TDMI CPU for embedded profiles and/or application software
Up to 17 GPIO lines
USB 2.0 Full Speed Device Interface
Master/Slave SPI
Synchronous Serial Controller
PWM Controller