User's Manual

BlueMod+C11/G2
Hardware Reference
www.stollmann.de Page 38 of 42
The rating of this distance depends on the intended use. Wall mounted or table desk
devices are assumed to fulfill this requirement. If the intended use is to wear the
portable modular transmitter close to the body, e.g. pocket device or head set a TCB
should be consulted. Rules can be found via
http://www.fcc.gov/oet/ea/eameasurements.html
Any notification to the end user of installation or removal instructions about the inte-
grated radio module is not allowed.
7.2.4 Labelling and re-test requirements for the End Product
Any End Product integrating the BlueMod+C11/G2 must be labeled with at least the
following information:
This device contains transmitter with
FCCID: RFR- C11G2
IC ID: 4957A-C11G2
Since the BlueMod+C11/G2 is a module to be integrated into a for the FCC authority
unknown end product, the FCC approval under this ID is a “Limited Modular Ap-
proval”, also called LMO. This implies that all OEM’s incorporating the Blu-
eMod+C11/G2 in their end product and wanting to ship to the USA or Canada have
to measure spurious emissions according to FCC Part 15.247 in a FCC accredited
EMC lab and have to keep the test report in their technical compliance folder ready
for being checked by US/CA market authorities.
7.3 Bluetooth Qualification
The BlueMod+C11/G2 is a qualified design according to the Bluetooth Qualification
Program Reference Document (PRD) V2.0. The Qualified Design ID (QDID) is:
B012419
For further information about marking requirements of your product attention should
be paid the Bluetooth Product Marking Guide at
https://programs.bluetooth.org/Download/Marking_Guide_20060601.pdf
According to the Bluetooth SIG rules (Qualification Program Reference Document –
PRD V2.1) you are required to perform the mandatory End Product Listing (EPL) for
your product. For further information see www.Bluetooth.org or contact Stollmann.