User's Manual

BlueRS+ manual 1.07work/09.2003
2. Installation
4 © Stollmann Entwicklungs- und Vertriebs-GmbH
2 Installation
2.1 Contents
This packet contains the following items:
• Bluetooth Serial adapter BlueRS+C2
• Mains plug power supply adapter (only BlueRS+C2-Dx)
• DTE interface serial cable (only BlueRS+C2-Dx)
• This user manual
2.2 Installation procedure
The following installation procedure is typical for the desktop model BlueRS+C2-Dx.
For all plug in modules the installation is dependent on the overall system and has to
be referred there.
Desktop model only:
To start using the BlueRS+C2-Dx, please follow these steps:
• Connect the serial port (DTE) of the BlueRS+C2 to the serial port (COM-port) of a
PC or other serial terminal equipment by using the supported DTE interface serial
cable.
Please make sure that the COM-port of the PC is not used for other purposes or
by other communication programs.
• Connect the power supply to a standard AC outlet. Please reference to page 5 for
selecting the correct plug for interfacing.
• The green LED on the BlueRS+C2-Dx front panel will come on to indicate that
the device has been power up. After some seconds the green LED will start
blinking to indicate power save mode.
• Optionally: Configure the BlueRS+C2-Dx Bluetooth interface if needed.
Configuration is required especially if you want to automatically connect to
another Bluetooth device (set up the remote Bluetooth address).
The BlueRS+C2 is now ready for use with Bluetooth links, please refer to the next
chapter for the configuration to use the terminal equipment together with the
BlueRS+C2.