User's Manual

BlueRS+ manual 1.07work/09.2003
5. Diagnostic and error messages
36 © Stollmann Entwicklungs- und Vertriebs-GmbH
5 Diagnostic and error messages
For the diagnostic of erroneous situations the following functionality is supported.
Please check first the behavior of LED displays, if an Bluetooth link can not be
established. Refer to list of LED displays on page 42.
5.1 Error messages from AT command set
When the extended result messages are selected using the command ATW1
Bluetooth error codes are displayed in addition to the standard AT result messages.
Bluetooth error codes are always coded as <xxxx>. The meaning can be taken from
the following tables Bluetooth error codes (see page 36).
5.2 Bluetooth error codes
Note: error codes marked with (i) are internal errors.
Error cause
hexadecimal
Meaning Translation
to AT result
codes
0x0000 no error, no explanation 3
0x0001 driver and application version mismatch 3
0x0002 application id provided is not correct 3
0x0003 unknown message code in message 3
0x0004 not enough resources to complete request (out of
descriptor etc)
3
0x0005 at least one parameter of the message is wrong 3
0x0006 no adapter plugged in 3
0x0007 too much outstanding messages in downstream
direction
6
0x0008 driver is busy, repeat request later 6
0x0009 error in message transport system (driver not correct
installed?)
3
0x0101 (i) HCI_ERR_UNKNOWN_COMMAND 3
0x0102 (i) HCI_ERR_NOCONNECTION 3
0x0103 bluetooth adapter crashed 3
0x0104/260 remote bluetooth device not found (wrong address?,
out of range?)
8
0x0105 authentication error(wrong pin code supplied?) 3
0x0106 (i) HCI_ERR_KEY_MISSING 3
0x0107 (i) HCI_ERR_MEMORY_FULL 3
0x0108/264 lost connection to remote bluetooth device
(
out of 3