User's Manual

1.07work/09.2003 BlueRS+ manual

4. BlueRS+C2 Configurator command set

When selecting DTE mode two additional inputs are evaluated and mapped to

the behavior of DCD (Pin 18) and RI (Pin 11).

0 : DTE mode

1 : DCE mode

Note: If you are working in DCE mode using the plug-on module, please make sure,

that PIN20 of connector P1 is connected to GND.

dbits asynchronous databits

Number of data bits asynchronous chars (default: 8) 7,8

Note: To use other data formats than 10 bit (8N1, 7E1, 7O1) you have to set br to

fixed speed.

flc flowcontrol

Flowcontrol to DTE

0 : No flowcontrol

3 : Hardware flowcontrol RTS/CTS (default)

5 : Hardware flowcontrol RTS/CTS additionally in AT command phase

flash load new firmware

This commands loads new firmware into the BlueRS+C2. The actual firmware

will be overwritten.

The firmware will be stored into the used part of the flash memory. While

uploading the following checks will be performed:

- File transfer protocol is XMODEM1K

- An overall firmware checksum is used.

- The firmware type written in the module header of the firmware must be

compatible to the hardware- and allowed firmware type (stored inside the

Bootloader).

This command is available only via the local serial port.

idle Idle data timeout

Timer to disconnect the Bluetooth link after inactivity on the serial line (sec).

0: inactive (default)

1..n: delay time to disconnect in seconds (1..255).