User's Manual

BlueRS+ manual 1.07work/09.2003
4. BlueRS+C2 Configurator command set
30 © Stollmann Entwicklungs- und Vertriebs-GmbH
cmds command set (note 1)
Command set for connection control
0: AT command set (default)
6: Automatic connection establishment when DTR is ON.
7: Automatic connection establishment when transmit data are available.
8: Automatic connection establishment independent of any status line.
12: No connection establishment initiated by this module.
Note: For details see the appropriate chapters.
cpua, cpua2, cpl3 Output pin behavior (BlueRS+C2 module only)
(under development)
Definition of the behavior of the output pins UA UA2 and L3 of BlueRS+C2.
The behavior can be configured by using one of the following setting to the value of
the list below.
The output level can be inverted by adding 128 to the desired value (defines the
output pin to low active).
0: always OFF. Default UA, UA2, L3
1: always ON
29: Bluetooth link established, same as DCD on V.24.
cri RI control
RI control
0 : RI is set with an incoming Bluetooth link request (default)
1 : RI follows remote RI line status
defa default settings
Sets up factory default parameter setting.
defa 0: setup all parameter concerning data port
defa 1: setup all parameter to factory defaults including Bluetooth
parameter.
devmode device mode strapping
Shows the mode of operation of the BlueRS+C2: DTE or DCE mode.