User's Manual

1.07work/09.2003 BlueRS+ manual

4. BlueRS+C2 Configurator command set

4.4 List of BlueRS+C2Configurator commands

The BlueRS+C2Configurator commands typed in must have the correct syntax and

be complete, including all blanks. Capital/small letter use is not important. The entry

is not case sensitive.

The bolded values are factory defaults. The usage is:

[?]<command>[=parameter]

Example to set the baudrate to 9600 baud:

br=4

Example to show the selected baudrate:

Example to show all selectable baudrates:

?br

To get an overview about the commands of your BlueRS+C2 some major commands

here as a preview:

show show the usually used parameter

showall show all changeable parameter

quit leave BlueRS+C2Configurator

help show all available commands

defa 1 setup factory default parameter set

save store parameter non volatile

at.sx AT command parameter set

AT command set only:

Handle AT specific settings.

Show and change AT S registers by entering the new value.

at.s0 show setting of S0-Register

at.s0=1 set Register S0 to 1

boad Bluetooth Device Own Address

With this command you can read out the own Bluetooth device address.

(read only)

Example:

boad

bpin Bluetooth device Pin (Passkey)