User's Manual

1.07work/09.2003 BlueRS+ manual

3. Using the BlueRS+C2

default: "BlueRS+C2 serial port"

Note:

To activate a new name for discoveries you have to make a power off/on

cycle.

**BRESTR Set restricted mode

Control the restricted mode for exchanging the Pin (Passkey). When set to 1

the setting of parameter bpin will be used to verify a pin with the requesting

Bluetooth device.

The pins of two bluetooth devices have to set to the same value, if one of

these devices allows only restricted connections. If a restricted connection has

been established one time between two Bluetooth devices these devices

know each other and are called as "paired" (see command "AT**BACCTAB"

for information about the paired Bluetooth device).

After a pairing has taken place Bluetooth links can be established between

these paired devices independent of the setting of the restricted mode!

To delete the pairing information within the BlueRS+C2 you have to issue the

command "AT**BDEL 1" .

**BPIN Bluetooth device Pin (Passkey)

Set the Pin for establishing a connection in the restricted mode by the

command "AT**BPIN=<old_pin>,<newpin>".

This Pin is always checked if

- the BlueRS+C2 is set to restricted mode

- the BlueRS+C2 is not set to restricted mode and the other Bluetooth

device is set to restricted mode.

The Pin has a fixed length of 4 digits, factory default: 0000.

To reset the Pin to factory default please use the command AT&F1 (all

parameter will be set to factory default.

Example: at**bpin=0000,1234 set Pin to 1234 (old Pin was 0000)

Note: After a pairing has taken place (Pin sucessful exchanged) Bluetooth

links can be established between these paired devices independent of the

setting of the restricted mode and the Pin!

**BOAD Bluetooth Device Own Address

With this command you can read out the own Bluetooth device address.

This value is can not be changed.