User's Manual

BlueRS+ manual 1.07work/09.2003
3. Using the BlueRS+C2
16 © Stollmann Entwicklungs- und Vertriebs-GmbH
3.2.1 Bluetooth specific AT commands
Setting up special Bluetooth parameter:
**BACCTAB Show pairing information
To show the pairing information (setup due to a successful restricted
connection) within the BlueRS+C2 you have to issue the command
"AT**BACCTAB" .
Example: at**bacctab
Response: 1: used: YES BD: 00803714ECA4 name:
OK
**BDEL Delete pairing information
To delete the pairing information (setup due to a successful restricted
connection) within the BlueRS+C2 you have to issue the command
"AT**BDEL 1" . The paired Bluetooth device can be read out by the command
"AT**BACCTAB".
Example: at**bdel 1
Response: OK
**BDINQ Inquire Bluetooth devices
With this request the automatic scan of all discoverable Bluetooth devices will
be initiated.
As a result the creation of the list bdlist will be initiated. The list can be read
out using the command at**bdlist. If the Inquiry-scan has not been terminated
while issuing the command at**bdlist, the BlueRS+C2 will return "inquiry
active".
The entries contain the Bluetooth device address, the Bluetooth device names
and available services (profiles).
The creation of this list may take up to 20 seconds due to the reaction time of
the accessible Bluetooth devices, a maximum of 9 Bluetooth devices can be
listed.
When issuing the command "at**bdinq 1" the inquiry scan will only request the
Bluetooth addresses, name and service inquiry will not be performed. The
maximum waiting time for responses of the Bluetooth devices is limited by a
time defined with the command "at**binqtim".
Example: at**bdinq request Bluetooth devices with name and service.
Response: OK
at**bdinq 1 request Bluetooth device addresses only