User's Manual

BlueRS+ manual 1.07work/09.2003
3. Using the BlueRS+C2
12 © Stollmann Entwicklungs- und Vertriebs-GmbH
Selects the local echo in command mode.
ATE No local echo
ATE1 Local echo on in command phase (default)
&F Load factory defaults
Factory default will be loaded. (for storing in non volatile memory please use the
command AT&W).
AT&F setup all parameter concerning data port.
AT&F1 setup all parameter including Bluetooth specifics and passwords.
H Disconnect
Disconnects existing Bluetooth connection, after issuing the escape sequence (see
page 9).
ATH
I Display version information
Displays different information about version number and settings:
ATI Returns the "Modem"-type; name of the terminal adapter
(“BlueRS+C2“)
ATI1 Returns "0"
ATI2 Returns "OK"
ATI3 Returns version string: "V1.xyz"
ATI4 Returns manufacturers name: "Stollmann E+V GmbH"
ATI5 Returns "OK"
ATI6 Returns copyright string: "(c) Copyright Stollmann GmbH"
ATI7 Returns "OK"
ATI8 Returns "ERROR"
ATI9 Returns "OK" (Plug&Play ID-Request not supported)
ATI77 Returns Bootloader version string
ATI99 Returns software creation date
&K Flow control
Selects the flow control behavior of the BlueRS+C2 while in data communication
phase.
AT&K No local flow control between the DTE and BlueRS+C2 is used
AT&K3 Local flow control is set to hardware handshake RTS/CTS
(default)