User's Manual

BlueRS+ manual 1.07work/09.2003
3. Using the BlueRS+C2
6 © Stollmann Entwicklungs- und Vertriebs-GmbH
3 Using the BlueRS+C2
Before using the BlueRS+C2 the address of another Bluetooth device has to be
selected - if not predefined by factory – that shall be the communication partner in
the Bluetooth link.
The compatible devices can be scanned using the configuration command "bdinq".
From that list one Bluetooth device has to selected.
If you are using an automatic connecting mode that Bluetooth address has to be
entered and stored using the configuration command "brad" (see
BlueRS+C2Configurator activation on page 24).
You can select different operation modes for the BlueRS+C2. These operating
modes are used to control Bluetooth links and to configure the BlueRS+C2.
Supported operating modes:
• Automatic connecting deriving from DTR or always connected.
• Automatic accepting of incoming connections.
• Asynchronous mode for devices that need the AT command set.
You can configure the BlueRS+C2 in the following ways:
• by using BlueRS+C2Configuration commands entered by the locally connected
PC.
• by using the AT command set entered by the locally connected PC.
• by using BlueRS+C2Configuration commands entered via the Bluetooth link
(remote configuration).