User's Manual

IMPORTANT

Read this information before using your wireless handheld phone

SAFETY INFORMATION

Exposure To Radio Frequency Signals

Your wireless handheld portable telephone is a low power radio transmitter

and receiver. When it is ON, it receives and also sends out radio frequency

(RF) signals. In August 1996, the Federal Communications Commission

(FCC) adopted RF exposure guidelines with safety levels for handheld

wireless phones. Those guidelines are consistent with safety standards

previously set by both U.S. and international standards bodies:

• American National Standards Institute (ANSI) IEEE C95.1-1992

• National Council on Radiation Protection and Measurement (NCRP) - Report

• International Commission on Non-Ionizing Radiation Protection (ICNIRP)

1996

• Department of Health and Welfare Canada, Safety Code 6

Those standards were based on comprehensive and periodic evaluations of

the relevant scientific literature. For example, over 120 scientists, engineers,

and physicians from universities, government health agencies, and industry

reviewed the available body of research to develop the ANSI Standard

(C95.1). The design of your phone complies with the FCC guidelines (and

those standards).

If you wear a handset on your body, to maintain compliance with FCC RF

exposure guidelines, use only approved carrying case, holster, or other body-

worn accessory. If you do not use a body-worn accessory, ensure the antenna

is at least one inch (2.5 centimeters) from your body when transmitting. Use of

non-approved accessories may violate FCC RF exposure guidelines.

Antenna Care

Use only the supplied or an approved replacement antenna.

Unauthorized antennas, modifications, or attachments could damage the

phone and may violate FCC regulations.