User's Manual

18
How to send a call
Dial the phone number with the code and press .
The display will show the number dialled, the word “Call” and the outgoing call
symbol:
N
Once connected, information on the call status will be displayed and, when the
call ends, on its length and possibly cost.
Note: Displaying the cost depends on the network and type of contract.
Correcting typing errors
Delete the last character shown on the display by pressing .
To delete the number completely, hold down .
International calls
Hold down  until + is displayed. Dial the international code of the required
country, the dialling code and phone number and press .
For instance, if you want to call the phone number 123456 in Rome: +39 06
123456; or Helsinki: [phone].
Automatic repetition
When the number dialled cannot be reached because it is engaged or there is
no answer, after the “Recall ?” message, it is possible, by pressing , to
enable the phone to make another 10 attempts at making the call (with
progressive delays: 5 sec., 1 min., etc.). An audible warning signals when the
connection is made.
Press  to disable the function, straight after or while attempting to
make the call.
Quickly send a call to a number in the phonebook
During stand-by, for a couple of seconds press the numerical key
corresponding to the position in the phonebook (from 1 to 9) where the
number you want to call has been saved (the call is sent automatically), or
:
Briefly press the corresponding number and then .
To be able to correct the number before sending it, key in the number of the
position in the phonebook following it with , make the correction and then
press .