User Manual

ZE51/61-2.4 RF module User Guide

1VV0300868 Rev.4 – 31/03/2011

II.2. Functional Requirements

The ZE51/61-2.4 module is a complete solution from serial interface to RF interface. The ZE51/61-2.4 module has

a digital part and a RF part.

The digital part has the following functionalities:

- Communication interface

- I/O management

- Micro controller with embedded software

The RF part has the following functionalities:

- 2.4 GHz IEEE 802.15.4 compliant RF transceiver

- Half Duplex bi-directional link

- RF front-end component with low noise Rx amplification and Tx power amplification (ZE61-2.4 module

only)

II.3. Software

The ZE51/61-2.4 module is provided pre-flashed with Telit in-house ZigBee® PRO stack. Please refer to ZigBee

PRO Protocol Stack User Guide [8] for detail information.

In case the customer needs to develop his own software, different tools are available:

 8051 compiler from IAR : http://www.iar.se/website1/1.0.1.0/244/1/

 CC debugger: http://focus.ti.com/docs/toolsw/folders/print/cc-debugger.html

The technical support for these tools will be done by the providing company.

All necessary drivers for ZE51-2.4 Usb dongle can be found under the following link:

http://www.ftdichip.com/Drivers/VCP.htm

A complete correspondence table of the connections between the CC2530 and the pin out of the module, as well

as the connections to the included STM M24C64 EEPROM can be found in chapter IV.3.

 In case, the customer wants to test the RF performances of the module, Telit can provide its own

proprietary test software that is available in the download zone together with description of all the

functionalities.