Software Manual

WE865-DUAL Software User Guide
1vv0300788 Rev. 0 08/08/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 16 of 48
When clients connect to each other through an AP, as shown above, they operate in
Managed/Infrastructure mode.
Another WiFi network topology that allows clients to directly connect to each other without APs
forming a peer-to-peer link is called Ad-Hoc.
4.2 WE865-DUAL Setup
4.2.1 WiFi Package Downloading
Before setting up WE865-DUAL, the components of the WiFi Package must be downloaded onto
GE863-PRO³ filesystem.
If you don’t have WE865-DUAL WiFi Package yet, you can download it from Telit’s official web site
Download Zone http://www.telit.com/en/products/download-zone.php
.
Connect the GE863-PRO³ to your host system via serial cable (use Debug port of the EVK, for further
details refer to document [2]). Open a terminal program (such as Hyperterminal) on your host system
and use for the connection the following parameters:
Bits per second: 115200
Data bits: 8
Parity: None
Stop bits: 1
Flow Control: None
Turn the GE863-PRO³ on. Once the system startup has finished, the terminal will display the shell
prompt as shown below.